A regulation playing surface with proper drainage, cured base, and accurate line striping, ready for year-round outdoor play.
On-Site Evaluation First
Itemised Written Estimate
HOA & Home Courts
Final Walkthrough Included
What Goes Wrong
Where rushed pickleball court builds fail, and how a proper sequence avoids it
Skipped Cure Interval
Acrylic coating applied before the base fully cures will delaminate under South Florida’s heat cycles within one or two seasons.
Staged Surface Application
The acrylic coat is scheduled only after the concrete or asphalt base reaches full cure, locking the coating to the slab permanently.
Flat-Grade Base
A perfectly level slab sounds right but traps water, standing pools after Broward’s summer storms create slippery footing and accelerate surface wear.
Engineered Drainage Slope
Grading establishes a consistent cross-slope across the full 30 ft x 60 ft footprint so run-off clears the surface after every storm.
Unmarked Clearance Zone
Striping only the 20 ft x 44 ft playing area without confirming the surrounding run-off clearance leaves players with no safe stopping room at the baselines.
Full Footprint Layout
The total court footprint is staked and graded first, so the playing area sits centered inside the required clearance zone before any base is poured.
Off-Spec Line Striping
Incorrect non-volley zone depth or service box width changes how the game plays and means the court cannot be used for sanctioned or HOA-organized matches.
Regulation Dimension Striping
Lines are measured and applied to USA Pickleball layout specifications, including the non-volley zone, service boxes, baselines, and sidelines.
Site assessment and grading come first. South Florida’s heavy rainfall means drainage slope and run-off clearance are confirmed before any base material is ordered. The minimum total footprint for a single court is 30 ft x 60 ft, with the 20 ft x 44 ft playing area centered inside that clearance zone. Grading establishes a consistent slope across the full footprint so water clears the surface after a storm.
Base preparation uses either a concrete slab or asphalt base layer depending on site conditions and intended use. Concrete offers a harder, more stable long-term foundation; asphalt is a common alternative where soil conditions or project scope favor it. Acrylic surface coating is applied after the base reaches full cure, skipping the cure interval causes the coating to delaminate under Fort Lauderdale’s heat cycles.
Line striping marks the non-volley zone, service boxes, and baselines to regulation dimensions. Net posts are set in concrete footings at the correct centerline position, and the net system is tensioned to the 34-inch center height required for regulation play. Growing pickleball activity in Broward County HOA communities means multi-court layouts on shared recreation land are increasingly common, and the same build sequence scales to two or four courts on a larger footprint.
Why Choose Us
Why Fort Lauderdale Sports Courts for pickleball court installation?
Every project starts with an on-site evaluation and ends with a signed-off walkthrough, nothing is left to assumption.
Written Estimate Before Any Work Starts
Base prep, surfacing, line marking, and net installation are listed as separate line items so you know exactly what is covered.
On-Site Drainage Evaluation Included
Every enquiry starts with a site visit to confirm grade, slope, and run-off clearance before a single material is ordered.
Backyard to Multi-Court HOA Builds
We arrange installs for home courts, HOA common areas, schools, and commercial recreation spaces across Broward County.
Resurfacing Available for Worn Courts
Existing slabs that need an acrylic recoat or crack repair are handled through the same local build partners.
Final Walkthrough Before Sign-Off
The finished court is inspected with you on-site, no job is closed until the surface, lines, and net system are confirmed correct.
How much does it cost to install a pickleball court?
Most pickleball court installations come in at $8,000-$15,000, depending on site conditions, surface choice, fencing, and lighting. An on-site evaluation and itemised written estimate are provided before any work begins, so you see exactly what each line item covers.
What can make the cost go up after the site is measured and graded?
Poor drainage, soft or uneven soil, and tree root removal are the most common cost drivers found during grading. Adding fencing, lighting, or a premium acrylic surface coating also increases the total. The itemised estimate flags these items before work starts, so there are no surprises mid-project.
Will a pickleball court fit in my backyard once you measure the clearances?
A regulation court with recommended safety clearance needs roughly 34 by 64 feet of usable, level ground. Many backyards in the Fort Lauderdale area can accommodate that, but an on-site evaluation confirms the exact fit, accounts for fencing setbacks, and identifies any grading needed before a commitment is made.
How big does a pickleball court need to be?
The playing surface itself is 20 by 44 feet. USA Pickleball recommends a minimum total footprint of 30 by 60 feet, which includes out-of-bounds space on all sides. Competitive or multi-player setups benefit from the full 34 by 64 feet to allow safe movement and reduce ball interference between adjacent courts.
How much space do I need around the court for safe play and movement?
USA Pickleball guidelines call for at least 7 feet of clearance on each side and 10 feet behind each baseline. That brings the recommended minimum footprint to 30 by 60 feet. Tighter lots can work, but reduced clearance increases the risk of players running into fencing or adjacent structures.
Is concrete or asphalt better for a pickleball court?
Concrete is more dimensionally stable in Florida’s heat and resists surface deformation better than asphalt over time. Asphalt costs less upfront but can soften and develop low spots in sustained high temperatures. Both surfaces accept an acrylic coating that delivers consistent ball bounce and safe footing, so the base choice mainly affects long-term maintenance frequency.
What does a pickleball court installation usually include?
A standard installation covers site preparation and base grading, concrete or asphalt sub-base, acrylic surface coating, line marking to regulation dimensions, net post installation, and a final walkthrough. Fencing and lighting are available as add-ons and are itemised separately in the written estimate so you can choose what fits your budget.
Does the project include the base, surfacing, lines, and net setup?
Yes. The itemised estimate covers base preparation, surfacing, line marking, and net post installation as standard scope items. Fencing and lighting are quoted separately. A final walkthrough confirms every element meets spec before the job is signed off.